84 14.2 Drainage Basins

A stream is a body of flowing surface water of any size, ranging from a tiny trickle to a mighty river. The area from which the water flows to form a stream is known as its drainage basin or watershed. All of the precipitation (rain or snow) that falls within a drainage basin eventually flows into its stream, unless some of this water is able to cross into an adjacent drainage basin via groundwater flow. An example of a drainage basin is shown in Figure 14.5.

Figure 13.4 Cawston Creek near Keremeos, B.C. The blue line shows the extent of the drainage basin. The dashed red line is the drainage basin of one of its tributaries. [SE]
Figure 14.5 A schematic diagram of the drainage basin of Cawston Creek near Keremeos, BC. The blue line shows the extent of the drainage basin. The dashed red line is the drainage basin of one of its tributaries.  Source: Steven Earle (2015), CC BY 4.0. View source.

An important characteristic of streams is their gradient: the rate of change in elevation with distance along the stream. A steep gradient has a rapid change in elevation with horizontal distance, and a shallow gradient has a slow change in elevation with horizontal distance. Cawston Creek drainage basin in BC is approximately 25 km2 and is a typical small drainage basin within a very steep glaciated valley. As shown in Figure 14.6, the upper and middle parts of the creek have steep gradients averaging about 200 m/km but ranging from 100 to 350 m/km, and the lower part, within the valley of the Similkameen River, is relatively flat at <5 m/km.

The shape of the valley has changed through time to result in the shape we see now. First, there was tectonic uplift (related to tectonic plate convergence). Then the landscape changed due to stream erosion and mass wasting (landslides). This was followed by several episodes of glacial erosion. Finally, there was post-glacial stream erosion up to the present time. The lowest elevation of Cawston Creek (275 m, where the creek flows into the Similkameen River) is its base level. Cawston Creek cannot erode below this level unless the Similkameen River erodes deeper into its flood plain (the area that is inundated during a flood). Base level is the elevation where a stream will no longer erode deeper into the bedrock or sediments it flows through, because the elevation of the stream does not drop below this level, and further erosion can only occur if there is an elevation drop to propel the water deeper due to the force of gravity.

The ocean is the ultimate base level, but lakes and other rivers act as base levels  for many smaller streams.

 

Figure 13.5 Profile of the main stem of Cawston Creek near Keremeos, B.C. The maximum elevation of the drainage basin is about 1,840 m, near Mount Kobau. The base level is 275 m, at the Similkameen River. As shown, the gradient of the stream can be determined by dividing the change in elevation between any two points (rise) by the distance between those two points (run). [SE]
Figure 14.6 Profile of the main portion of Cawston Creek near Keremeos, BC. The maximum elevation of the drainage basin is about 1,840 m, near Mount Kobau. The base level is 275 m, at the Similkameen River. As shown, the gradient of the stream can be determined by dividing the change in elevation between any two points (rise) by the distance between those two points (run). Source: Steven Earle (2015), CC BY 4.0. View source.

The water supply for the Vancouver, BC metropolitan area comes from three large drainage basins on the north shore of Burrard Inlet, as shown in Figure 14.7. This map illustrates the concept of a drainage basin divide. The boundary between two drainage basins is the ridge of land between them. A drop of rain falling on the boundary between the Capilano and Seymour drainage basins, for example, could flow into either basin. Rain falling on the Capilano basin side cannot flow into the Seymour drainage basin, because of the drainage basin divide.

 

Figure 14.7 The three drainage basins that supply water to the metropolitan Vancouver, BC area. Source: Alaidlaw (2016), CC BY-SA 2.0. View source.

The pattern of tributaries within a drainage basin depends largely upon the type of underlying rock, and on structures within that rock such as folds, fractures, and faults. Three types of drainage patterns are illustrated in Figure 14.8. Dendritic patterns, which are by far the most common, develop in areas where the rock (or unconsolidated material) beneath the stream does not have structures that control the stream flow patterns such as folds and joints; the materials can be eroded by the stream equally easily in all directions. Most areas of British Columbia have dendritic patterns, as do most areas of the prairies and the Canadian Shield.

Trellis drainage patterns typically develop where sedimentary rocks have been folded or tilted, and then eroded to varying degrees depending on their resistance to erosion. The Rocky Mountains of BC and AB have some fine examples of trellis drainage.

Rectangular patterns develop in areas that have very little topography and a system of bedding planes, fractures, or faults that form a rectangular network. Rectangular drainage patterns are rare in Canada.

 

Figure 13.7 Typical dendritic, trellis, and rectangular stream drainage patterns. [SE]
Figure 14.8 Typical dendritic, trellis, and rectangular stream drainage patterns. Source: Steven Earle (2015), CC BY 4.0. View source.

In many parts of Canada, especially relatively flat areas with thick glacial sediments, and throughout much of Canadian Shield in eastern and central Canada, drainage patterns are chaotic , also known as deranged (Figure 14.9, left). Lakes and wetlands are common in this type of environment.

Radial drainage (Figure 14.9, right) is a pattern that forms around isolated mountains (such as volcanoes) or hills. The individual streams that radiate out from the hill typically have dendritic drainage patterns.

 

Figure 13.8 Left: a typical deranged pattern; right: a typical radial drainage pattern developed around a mountain or hill. [SE]
Figure 14.9 Left: a typical deranged pattern; right: a typical radial drainage pattern developed around a mountain or hill.  Source: Steven Earle (2015), CC BY 4.0. View source.

Practice with Drainage Networks

 

The process of a stream eroding downward into bedrock is called downcutting. Over geological time, and during tectonic quiescence, a stream will erode its drainage basin into a smooth profile similar to that shown in Figure 14.10. This is called a graded stream. Graded streams are steepest in their headwaters and their gradient gradually decreases toward their mouths. Ungraded streams are still in the process of rapidly eroding and downcutting their drainage basin, they have steep sections at various points, and typically have rapids and waterfalls at numerous locations along their lengths (e.g., Cawston Creek, Figure 14.6).

 

Figure 13.9 The topographic profile of a typical graded stream. [SE]
Figure 14.10 The topographic profile of a typical graded stream. Source: Steven Earle (2015), CC BY 4.0. View source.

A graded stream can become ungraded if there is renewed tectonic uplift, or if there is a change in the base level. Base level changes can occur due to tectonic uplift or some other reason such as construction of a dam downstream. As stated earlier, the base level of Cawston Creek is defined by the level of the Similkameen River, but this can change, and has done so in the past. Figure 14.11 shows the valley of the Similkameen River in the Keremeos area. The river channel is just beyond the row of trees. The green field in the distance is underlain by material eroded from the hills behind and deposited by a small creek (not Cawston Creek) adjacent to the Similkameen River when its level was higher than it is now. Some time in the past several centuries, the Similkameen River eroded down through these deposits (forming the steep bank on the other side of the river), and the base level of the small creek was lowered by about 10 m. Over the next few centuries, this creek will erode through the sediments and eventually become graded again.

 

Figure 13.10 An example of a change in the base level of a small stream that flows into the Similkameen river near Keremeos. The previous base level was near the top of the sandy bank. The current base level is the river. [SE]
Figure 14.11 An example of a change in the base level of a small stream that flows into the Similkameen River near Keremeos. The previous base level was near the top of the sandy bank. The current base level is the Similkameen River, located on the far side of the line of trees. Source: Steven Earle (2015), CC BY 4.0. View source.

Another example of a change in base level can be seen along the Juan de Fuca Trail on southwestern Vancouver Island. As shown in Figure 14.12, many of the small streams along this part of the coast flow into the ocean as waterfalls. It is evident that the land in this area has risen by about 5 m in the past few thousand years, probably in response to deglaciation. The streams that used to flow directly into the ocean now have a lot of downcutting to do before they will be a graded stream again.

 

Juan de Fuca Trail
Figure 14.12 Two streams with a lowered base level on the Juan de Fuca Trail, southwestern Vancouver Island. Source: Steven Earle (2015), CC BY 4.0. View source.

Sediments accumulate within the channel and flood plain of a stream, and then, if the base level changes, or if there is less sediment supplied to the stream to deposit, the stream may cut down through these existing sediments to form terraces. A terrace on the Similkameen River is shown in Figure 14.11 and terraces on the Fraser River are shown in Figure 14 .13.

 

Figure 14.13 Terraces on the Fraser River north of Lillooet, BC (above the river on the left-hand side of the image). Source: China Crisis (2007), CC BY-SA 3.0. View source.

In the late 19th century, American geologist William Davis proposed that streams and the surrounding terrain develop in a cycle of erosion (Figure 14.14). Following tectonic uplift , the stream patterns are immature. Streams erode quickly, developing deep V-shaped valleys that tend to follow relatively straight paths. Gradients are high, and profiles are ungraded. Rapids and waterfalls are common. As the landscape matures, the streams erode wider valleys and deposited thick sediment layers. Even after maturity, gradients are slowly reduced and grading increases. In old age, streams are surrounded by rolling hills, and they occupy wide sediment-filled valleys. Meandering patterns are common, and erosion now is focused towards the channel walls, with little downcutting.

 

Figure 13.13 A depiction of the Davis cycle of erosion: a: initial stage, b: youthful stage, c: mature stage, and d: old age. [SE]
Figure 14.14 A depiction of the Davis cycle of erosion: a: initial stage, b: youthful stage, c: mature stage, and d: old age . Source: Steven Earle (2015), CC BY 4.0. View source.

Davis’s work was done long before the idea of plate tectonics, and he was also not familiar with the impacts of glacial erosion on streams and their environments. While some parts of his idea are out of date, it is still a useful way to understand streams and their evolution.  Plate tectonic activity and other processes such as isostatic rebound after glaciation results in uplift that alters stream gradients, so streams are constantly adjusting due to these changing conditions. It would be relatively rare to find a stream that is able to mature through all of these stages without interruption.

License

Icon for the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License

Physical Geology - H5P Edition Copyright © 2021 by Karla Panchuk is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License, except where otherwise noted.

Share This Book